Barricade Tape
This section is designed for the Hardware store/building supplies merchant who needs quick access to view our range of manufactured or imported range of products. If we dont have what you are looking for then please contact us for assistance.
| Code | Roll Size |
| MBWT50 | 50mm x 30m |
| MBWT150 | 150mm x 30m |
| MBWT200 | 200mm x 30m |
| MBWT50x10 | 50mm x 10m |
| MBWT150x10 | 150mm x 10m |
Features
- Simple 4 step installation, save time reducing costs
- 1.2mm thick adhesive layer
- Reliable and dependable weather tightness
- Low temperature adhesion
- Can be applied as low as 5° Cdust.
Applications
Masons Barricade Tape is a modified bituminous tape that has been tested and passed by BRANZ AC148 as required by NZBC Acceptable Solution E2/AS1, paragraph 4.3.11, and designed to be used for:- To seal around windows, doors, and other joinery openings as a secondary defence against water penetration
- For timber and steel framed buildings
- For a risk score between 0-20 in accordance with NZBC Acceptable Solution E2/AS1
- In NZS3604 Building Wind Zones up to and including ‘Very High’ .
Installation
Windows / Doors / Steel Frame Flashing:
- Masons Barricade Tape must be installed in accordance
with these instructions. Ensure the Barricade Tape
completely covers the joinery opening.
- The building wrap is installed as shown to the exterior
face of the framing. At window and door openings it
is cut on a 45° angle away from each corner, then the
flaps are folded into the opening and secured.
- To ensure maximum adhesion, ensure the substrate
surface is clean, dry and free from any dust or other
contaminants.
- Barricade Tape must not be stretched. When joining 2 sections of tape, overlap by 100mm or more
Window Head Flashing Installation
- Apply Masons Barricade Tape to the top of the window head flashing upstand and the building wrap.
Refer to PDF for full installation Guide.
